Installing a Brick Paver Walkway or Common Bricks

The use of Bricks or Pavers to develop a pathway or patio complements a home in a method that is unrivaled. In addition, setting up a Brick or Paver pathway does not necessarily require a pro.

The key to installing a Brick or Paver Walkway is to very first appropriately prepare the location where the bricks/pavers are to be installed. In addition, string lines should be strung on each side of the walkway.
Once the location has been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. The height between the tamped down sand and the stringline should equate to the thickness of the brick or paver.

Now that you have a steady base, put a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the ready location. These strips will serve as your sidewalk border and help to preserve the stability and shape of the walkway. You can get these plastic strip borders at a lot of house improvement stores. The strips must be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

Once this is done, you can then begin to lay the bricks/pavers. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist preserve the stability of the pathway.

Undoubtedly bricks/pavers will need to be cut or divided when constructing the sidewalk. Unless you wish click here to purchase or rent a pricey wetsaw, I would recommend purchasing a basic brick/paver splitter. It is generally a chisel with a broad end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you want to break the brick. Using a hammer strike the butt end of the chisel securely. You may require to do this a couple of times. You might likewise want to turn the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver need to break cleanly. If your sidewalk has curves you will require to buy/rent a wetsaw.

After setting up the bricks, develop the outside edges with additional sand, and then shovel in the topsoil and pack down securely.
Spread stone dust over the brand-new pathway and sweep into the cracks. This will complete the interlocking of the bricks and assist to get rid of any weed growth.


In addition, installing a Brick or Paver sidewalk does not necessarily require a pro. The key to setting up a Brick or Paver Walkway is to very first correctly prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, place a 1" pipeline or journal board the length of the walkway on either side of the pathway. These get more info strips will act as your pathway border and assistance to maintain the stability and shape of the walkway. Undoubtedly bricks/pavers will need to be cut or divided when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *